FA00859M02
–
03/2022
2
www.came.com
818XC-0012 Installation manual of locking device
1)
Fix by front hooking, the locking device on the drive unit profile, place in C Measure (see the manual of the automation),
and secure with screws.
2)
Fix the hook bracket on the carriage in relation of the door type (see the manual of the automation).
3)
If the hook bracket touches the mechanical stop bracket of the automation, use the included spacer.
4)
Manually move the door in closed position and adjust the bracket and the locking device position to get the proper
attachment of the locking device.
5)
Connect the locking device to the connector LK of electronic control using the included cable (the excess may be
shortened). Observe the color of the wires (red to red and black to black).
6)
In automation for emergency exits, fix the microswitch on locking device, as shown in the figure, using the included
screws. Connect the microswitch to terminals of the electronic control, using the included cable (common = 1; N.O. = S1).
7)
Switch the unlock rope through present hole on the left end cap, until you reach the locking device. Switch the rope
through the spring and lock, making a lap around the bracket. With the door in closed position and locked, check that by
manually pulling the unlock rope, the leaves can be opened manually, even in the event of a power failure, and remain
unlocked until electrical operation is restored.
8)
In case you need to move the unlock rope through the right end caps, proceed as follows: unscrew the 4 lower screws
(a)
of the lock, rotate the locking device so that the spring
(b)
is on the right, re-screw the 4 lower screws
(a)
.
CAME S.P.A.
Via Martiri Della Libertà, 15
–
31030 Dosson di Casier
–
Treviso
–
Italy
EN
