2
1
50
84
105
p.
6
- M
an
u
al
:
F
A
0
0
6
0
5
-E
N
FA
0
0
6
0
5
-E
N
v.
1
- 0
1/
2
0
17 - © C
A
M
E S
.p.
A
. - T
h
e c
onte
nts of th
is
m
an
u
al
m
ay b
e c
h
an
g
ed, at a
ny ti
m
e, a
n
d w
ith
ou
t n
oti
ce
.
Laying the anchoring plate
Set up a foundation frame that is larger than the anchoring plate and sink it into the dug hole. The foundation frame must jut out by 50 mm above
ground level.
Fit an iron cage into the foundation frame to reinforce the concrete.
Fit the bolts into the fastening plate and tighten them using the nuts. Remove the pre-shaped clamps using a screw driver or pliers.
If the rack is already there, place the anchoring plate, being careful to respect the measurements shown in the drawing.
⚠
Careful! The tubes must pass through their corresponding holes.
Fill the foundation frame with concrete. The plate must be perfectly level with the bolts which are entirely above surface.
Wait at least 24 hours, for it to solidify.
Remove the foundation frame and fill the hole with earth around the concrete block.
