19
Accessory Assembly
LINEAR ACCESSORY 30-50 cm. (Picture 1)
Tests based on EN 12445 norm, impose points of measure and distances well defined.
n
For 30 cm and 50 cm it is necessary the linear accessory 30-50cm.
n
MOUNT THE INSTRUMENT HOLDER (Picture 2-3)
Remove the central screw of the handle, by means of enclosed hexagonal key.
n
Remove the bolt and insert the holder, making correspond the
spindle
with the
notch
hole
in
n
the Instrument body.
Fix the holder by means of enclosed knob.
n
Verify that thread spindle of knob is well screwed to handle.
n
REMARK: it is possible to not use the handle, but use the enclosed blind bolt.
n
MOUNT SPACERS (Picture 4)
For 30cm measures, insert the spacer with head on the Instrument holder.
n
Push with strenght, and then turn the spacer following the joint.
n
If necessary, add the additional spacer for 50cm measures.
n
JOINT ACCESSORIES (Picture 5)
To assemble accessories and spacers correctly, it is necessary to insert with strenght the tube
n
with
spindle
aligned to reference
notch
, and then turn of 180° to insert the joint secur-lock.
ANGULAR ACCESSORY (Picture 6-7)
To assemble correctly the angular accessory, it is necessary to insert the element with
ring
n
terminal into the holder with screw and blind bolt.
Attention! The four washers must be equally divided,
two
on the
right
and
two
on the
left
of
n
the ring element.
To use the angular accessory, it is necessary to fix The Instrument with the holder and the
n
enclosed spacers (1,25m. or 0,60m), and then press the stirrup on the floor with a foot, while
supporting the tube of spacer with an hand.
ACCESSORY ASSEMBLY
6
2
4
1
3
7
5