MECHANICAL
ADJUSTMENTS
J....
,0'"
VERTICAL ADJUSTMENT R'
To obtain correct vertical alignment oflhe door wings, adjust
the trolleys as follows:
- Loosen screws A.
- Turn vertical adjustment screw B until the door wing(s) is/
are as perpendicular
to the ground
as possible.
If the
automation system is being used to power two sliding door
wings, adjust this screw so that no gap is left between the
door wings when they are closed.
- After completing
the adjustments,
tighten screws A and
move the door wing manually to make sure that there is no
mechanical interference between the moving door wing(s)
and the pavement along the entire line of movement.
If necessary, the entire door wing can be raised by adjusting
both trolleys.
TRANSVERSE ADJUSTMENT R'
The vertical plane of the rollers on the trolleys must be parallel with the beam. If the trolleys are
out of alignment (i.e., if the door wing does not slide easily), proceed as follows:
- Loosen nuts and bolts C;
- Align the trolleys with the guide track (for example,
by
measuring distance
a
between the body of the trolley and the
beam);
- Move the door wing manually to make sure that there is no
mechanical
interference
between the moving door wing(s)
and non-moving
parts/door
wings along the entire line of
movement.
- Tighten the bolts firmly
to fasten the trolleys.
."
,~
,
.--1o.~e
-~~-
•
1--11'
•
-
-
Guide
track
(,
i
-
HORIZONTAL ADJUSTMENT R'
(for Corsa 2, only)
For fine adjustment (:I:4 mm) of
the point where the two door
wings meet, loosen nuts and
bolts 0 and move the two door
wings at the same time.
To obtain a coarser adjustment,
remove
the belt attachment
system by loosening nuts and
bolts E.
After adjustment,
tighten
the
bolts back down.
-----------------------------------
"
