FA00150-EN v.7 - 06/2017
36
CAME S.p.A.
14. START-UP PROCEDURE OF THE AUTOMATIC SLIDING DOOR
14.1 Preliminary checks.
At the end of the installation, move the doors manually and make sure that operation is smooth and without friction. Check
the solidity of the structure and the proper attachment of all the screws. Check the correctness of all electrical connections.
14.2 Before connecting any security devices, leave the jumper on terminals safety (41-8A, 41-8B, 41-6A, 41-6B, 1-S1).
14.3 Giving power supply and connect the battery, if present.
Note: every time you switch on the automation performs a self-test (from 3 to 30 seconds). The first opening and closing
cycle is at low speed to allow the automatic learning.
14.4 To ensure that the electronic control has the factory settings, restore via the menu:
MEM> FSET> YES (confirm by pressing ENTER for 1 second).
Note: if the door is 1-leaf opening to the left, set the opening direction as follows:
MENU > OPEN >
←
(confirm by pressing ENTER for 1 second).
Note: if the door is BIG model, set the type of automation as follows:
MENU > DOOR > SL5B (confirm by pressing ENTER for 1 second).
14.5 Perform the menu settings as described in Chapter 13. Use OPEN button to perform the opening door, and verify the
correct operation of the door.
Note: the automation automatically detects any obstacles during the closing movement (reversal movement) and opening
(stopping movement).
14.6 Connect one at a time, opening and safety devices to protect the closing cycle of the door, as described in Chapter 12.5,
and verify proper operations.
Note: verify that the opening access is properly protected by safety sensors, in accordance with the requirements of the
European standard EN16005 (annex C).
Note: verify that the
opening access is properly
protected by safety
sensors, in accordance
with the requirements of
the European standard
EN16005 (annex C).
14.7 Connect one at a time, safety devices to protect the opening cycle of the door, as described in Chapter 12.7, and verify
proper operations.
Note: if the gap between the door and the fixed parts meet the
requirements of the European standard EN16005 (Chapter 4.6.2.1.a), the
safety sensors are not needed (X ≤ 100 e Y ≥ 200).
14.8 At the end of the automation starting, deliver to the owner the user instructions, including all warnings and information
necessary to maintain the security and functionality of the automatic door.
14.9 FLUO-SL automations are feature of label on the right end cap, containing
the required information by European standards EN16005 and EN60335-2-103.
Note: the manufacturer of the automatic sliding door have to add his own label
identifying the installation.