Page
13
- Manual
FA01626-EN
- 02/2023 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
With the 001G03250 boom, fit the rope light.
1
Cut the rope light to the desired length at the points marked with a scissors symbol (one every metre).
2
Insert the rope light into the grooves on both sides of the boom.
3
Fit the insulating cap to one end of the rope light.
4
Thread the power supply cable through the hole in the middle of the transmission shaft plate.
5
Drill through one of the pre-drilled holes in the electrical panel and fit the cable gland. Insert the cable and make the connections.
FLEXILIGHT CE
V ELI-LIGHT b
24
y ELIOS
Fit the boom into the fastening flange.
Fasten the boom with the screws.
