p.
16
- Manual
FA01354-EN
- 07/2019 - © C
AME S.p.A. - The cont
ents of this manual may change, at any time, and without notice. - Original instructions
Command and control devices
2
24
10
S1GND
A B
11 E1 E6 TS 1
2
3 3P 4
5
7
2 CX CY CZ
FA FC
STB
TAMPER
MOTOR
BLOCK
+
-
3
2
1
4
6
7
8
9
5
1
Antenna with RG58 cable
2
Card reader
3
Transponder selector switch
4
Keypad selector
5
TEMPORARY STOP button (NC contact)
It stops the boom and excludes the automatic closing; after 15 seconds the
boom opens slowly.
If the contact is not used, it must be deactivated during the
programming.
6
Control device - OPEN ONLY function - NO contact
For opening only.
The contact can be programmed for the hold-to-run function.
7
Control device - OPEN ONLY function - NO contact
For opening only.
The contact must be used only for operators working in paired mode.
8
Control device - CLOSE ONLY function - NO contact
For closing only.
The contact can be programmed for the hold-to-run function.
9
Control device - OPEN-CLOSE function - NO contact
For opening and closing.
Safety devices
Connect the safety devices to the CX, CY and/or CZ inputs.
During programming, configure the type of action that must be performed by the device connected to the input.
If contacts CX, CY and CZ are not used they must be deactivated during programming.
DELTA photocells
Standard connection
Multiple photocell pairs can be connected.
DELTA photocells
Connection with safety test
Multiple photocell pairs can be connected.
See function F5, safety devices test.
2
10
A B
11 E1 E6 TS 1
2
3 3P 4
5
7
2 CX CY CZ
FA FC
MOTOR
BLOCK
+
10
-
11 NO C NC
+
10
-
11
RX
TX
2
10
A B
11 E1 E6 TS 1
2
3 3P 4
5
7
2 CX CY CZ
FA FC
MOTOR
BLOCK
-
+
10
-
11 NO C NC
+
10
-
11
DELTA Collegamento test sicurezza
RX
TX