p.
23
- Manual
FA01354-EN
- 07/2019 - © C
AME S.p.A. - The cont
ents of this manual may change, at any time, and without notice. - Original instructions
Remove all
It removes all registered users.
U3
Remove all
OFF (Default)
ON
Radio-frequency decoding
For choosing the type of radio coding of the transmitters enabled to control the operator.
Choosing the type of radio coding of the transmitters [Rolling code] or [TW key block], the transmitters with different type of radio coding previously
stored, will be deleted.
U4
Radio-frequency decoding
1 = All (Default)
2 = Rolling code
3 = TW Key Block
Boom length
Sets the boom length.
A1
Boom length
1 = up to 2.5 m (Default)
2 = from 2.5 to 3.8 m
Motor test
Verification of the correct opening direction of the boom.
If the keys do not execute the commands correctly, invert the boom opening direction.
A2
Motor test
ON = to activate the TEST.
The button > makes the motor turn in clockwise direction.
The button < makes the motor turn in a counter clockwise direction.
Travel calibration
It starts the travel self-learning.
A3
Travel calibration
ON = To start calibration
Parameters reset
Restore factory settings except for the functions: [Radio decoding], [Boom type] and the settings related to the travel calibration.
A4
Parameters reset
OFF (Default)
ON
Maneuvers counter
For viewing the number of maneuvers done by the operator (1 = 1000 maneuvers).
A5
Maneuvers counter
FW version
It displays the number of the firmware version and GUI installed.
H1
FW version