p.
6
- Manual
FA01354-EN
- 07/2019 - © C
AME S.p.A. - The cont
ents of this manual may change, at any time, and without notice. - Original instructions
Control board
1 -Buttons for programming
2 -Display
3 -USB stick connector
4 -Encoder connector
5 -Motor connector
A p.n. ferrite is applied to the cable ECQK922091
6 -Terminal board for barrier status
7 -Terminal block for connecting the warning LED strip
8 -Terminal board for connecting the electric lock
9 -Accessories fuse
10 -Control board fuse
11 -Motor fuse
12 -Terminal block for motor power supply
13 -Terminal board for power supply to the control board
14 -Terminal board for NC contact for open cover
15 -Terminal board for NC contact for boom drop away
16 -Terminal board for NC contact for gearmotor release
17 -Terminal block associated with the RSE_2 connector for CRP or CAME KEY
connection
18 -Terminal block associated with the RSE_1 connector for combined or
alternate connection
19 -Terminal board for connecting control and safety devices
20 -Terminal board for connecting the keypad selector
21 -Terminal board for connecting the transponder selector
22 -Terminal board for connecting the antenna
23 -Connector for the R700 or R800 decoding card
24 -Connector for plug-in radio frequency card (AF)
25 -RSE_1 connector for RSE card
26 -RSE_2 connector for RSE card
A B GND
A B GND
R G B
24
10
S1 GND
A B
11 E1 E6 TS 1
2
3 3P 4
5
7
2 CX CY CZ
0
30 0
TAMPER
FCA CM1 FCC CM2
EB
MOTOR
BLOCK
ARM
EB
+
2
25
24
22
21
20
19
16
15
17
18
14
13
12
3
5
4
4
23
26
6
7
8
9
10
11
1