p.
6
- Manual
FA01313-EN
- 02/2019 - © C
AME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
Control board
1 - Buttons for programming
2 - Display
3 - USB stick connector
4 - Encoder connector
5 - Motor connector
A p.n. ferrite is applied to the cable ECQK922091
6 - Terminal board for barrier status
7 - Terminal block for connecting the warning LED strip
8 - Terminal board not used
9 - Accessories fuse
10 - Terminal block for motor power supply
11 - Terminal board for power supply to the control board
12 - Terminal block for connecting the open cover safety microswitch (NC
contact)
13 - Terminal board for NC contact for boom drop away
14 - Terminal board for connecting the unlocked gearmotor safety microswitch
(NC contact)
15 - Terminal boards for connecting travel end microswitches (NC contact) *
16 - Terminal board associated with the RSE_2 connector for CRP connection,
IO 485 card or Modbus RTU interface
17 - Terminal board associated with the RSE_1 connector for combined
connection, alternate or CRP
18 - Terminal board for connecting control and safety devices
19 - Terminal board for connecting the keypad selector
20 - Terminal board for connecting the transponder selector
21 - Terminal board for connecting the antenna
22 - Connector for the R700 or R800 decoding card
23 - Connector for plug-in radio frequency card (AF)
24 - RSE_1 connector for RSE card
25 - RSE_2 connector for RSE card
26 - Connector for the clock card (806SA-0120)
* Used only for GPX40MGP
A B GND
A B GND
R G B
2
24
10
S1 GND
A B
11 E1 E6 TS 1
2
3 3P 4
5
7
2 CX CY CZ
0
30 0
FA FC
TAMPER
FCA CM1 FCC CM2
EB
MOTOR
BLOCK
ARM
EB
+
2
26
24
23
21
20
19
18
15
14
13
16
17
12
11
10
3
5
4
4
22
25
6
7
8
9
1
