10 11 E1 E6 RX TX 1 2 3 3P 4 5 7 CX CY
A B GND
A B
S1 GND
A
CCESS CONTR
OL
3
2
1
4
6
7
8
9
5
page
16
- Manual
FA01260-IT
- 10/2018 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice
. - T
ranslation of the original instructions
Command and control devices
1 - Antenna with TOP-RG58 cable.
2 - Button - Total stop - NC contact – Boom stop that excludes any automatic closing; to resume movement, use the control device.
If the contact is not used, it must be deactivated during the programming.
3 - Control device - OPEN ONLY function- NO contact - Allows only opening.
The contact can be programmed for the hold-to-run function.
4 - Control device - OPEN ONLY function- NO contact - Allows only opening.
The contact must be used only for operators working in compass or combined mode.
5 - Control device - CLOSE ONLY function- NO contact - Allows only closing.
The contact can be programmed for the hold-to-run function.
6 - Control device - OPEN -CLOSE function- NO contact - Allows only opening and closing.
7 - Keypad selector.
8 - Transponder selector switch.
9 - Card reader.
Summary of Contents for I1PB0500026
Page 2: ...4 4...
