page
27
- Manual
FA01260-IT
- 10/2018 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice
. - T
ranslation of the original instructions
PROBLEM
REFERENCE
CHECK
The boom neither opens nor closes
1-2-3-4-6-8-
13-18
1 - Close the inspection hatch using the key
The boom opens but does not close
4-7
2 - Deactivate the MAINTAINED ACTION function
The boom closes but does not open
4-7-12-13
3 - Check the power supply and fuses
The barrier does not automatically close
11-12-13
4 - The NC contacts are open
The barrier does not work with the transmitter
2-14-16
6 - Deactivate the MASTER-SLAVE function
The boom's direction of travel is inverted
7-18
7 - Check the boom's balancing and spring tautness
Only one transmitter works
22 series
8 - Deactivate the OBSTRUCTION DETECTION function
The photocells do not work
12-23-24
11 - Activate the AUTOMATIC CLOSING function
The warning LED flashes quickly
4 series
12 - Check the proper direction of travel
The warning LED stays lit
13 series
13 - Check the control devices
The boom does not reach the travel end
7 series
14 - Replace the AF card
The boom cannot be balanced
7-15
15 - Check the length ratio between boom and applied
accessories
The barrier does not slow down
7-15
16 - Memorize the radio code again
The barrier does not work with emergency batteries
8-25-26
18 - Adjust the sensitivity
The boom starts slow
7 series
22 - Enter or duplicate the same code on all transmitters
23 - Activate the photocells
24 - Connect the photocells serially instead of in parallel fashion
25 - Check the batteries
26 - Respect the photocell's input voltage polarities
TROUBLESHOOTING
ERROR MESSAGE
The error messages appear on the display or are notified by LEDs.
.
Er1
The boom travel calibration was interrupted by the activation of the STOP button.
Er3
Encoder is broken.
Er4
Safety test error.
Er5
Insufficient working time.
Er6
Maximum number of obstructions detected.
Er7
Transformer overheating.
Er8
The inspection hatch is open.
C0
Contact 1-2 (NC) is open.
C1, C4, C5 or C9
The (NC) contacts are open.
The warning LED
flashes
The control board is not yet calibrated for the boom travel.
Summary of Contents for I1PB0500026
Page 2: ...4 4...
