18
CAMEC ELITE
®
2
EM303
Ref: ELITE 2 EM303-0715Rev.A.
Changing batteries in the remote control:
When the battery is empty (blue 9V battery LED (Fig. 15J)
is blinking), it needs
Open the rear cover of the handset (Fig. 16A).
Take out the dead/old battery and dispose in the appropriate
way.
Install a new replacement battery (Fig. 16.1). Make sure to
use a leak proof PP3 (9Volt) battery (no claims under
guarantee can be considered for damage caused by
leaking batteries).
Close the rear cover again.
Dead and used batteries may leak and damage the
remote control handset! Remove the batteries if the
handset is not going to be used for an extended period.
OPERATION - ELECTRONIC CONTROL UNIT
The electronic control unit (32), which is mounted
inside your caravan, is responsible for controlling the
manoeuvring system.
The control unit has three LED’s, one push button and
one slide switch (Fig. 17):
Green LED
(Fig. 17B) Power LED continuously illuminated
when system is activated (by moving
slide switch to “On”-I).
If the handset is far away from the control unit,
beyond the connection distance, this LED will go
out.
Blue LED
(Fig. 17C)
Error message LED
concerning caravan
battery
Blue LED is blinking (2 times blinking,
break, 2 times blinking, break etc.)
Battery voltage too low (<10V). Battery needs to
be recharged.
Blue LED is blinking (4 times blinking,
break, 4 times blinking, break etc.)
Battery voltage too high (over charged). Try to
discharge the battery by turning on an appliance
(e.g. a lamp or water-pump).
Red LED
(Fig. 17D)
Red LED is blinking (6 times blinking,
break, 6 times blinking, break etc.):
Amp overload protection is activated. Wait about
60 seconds and try again.
In general all error messages will reset automatically after one minute. If this is not the case, reset the electronics of
the manoeuvring system by switching off the system via the isolation switch and the remote control handset for at
least 15 seconds and then turning it on again.
The Reset Button
(Fig. 17A): The remote control handset and the control unit are synchronised with each other in
the factory. If the control unit or the remote control handset is replaced, they must be re-synchronised as described
below:
to be replaced.
•
•
•
•
