9
CAMEC ELITE
®
2
EM303
Ref: ELITE 2 EM303-0715Rev.A.
Re-check that all bolts/nuts have been tightened to the correct torque!
INSTALLATION - ELECTRICAL/ELECTRONIC COMPONENTS
Make sure the 12V supply from the battery and any 240V electricity supply are disconnected.
•
Remove battery cable terminals and disconnect any external electrical power before starting work.
•
Find a suitable place for the electronic control unit (32), such as a storage area, under a seat or a bed. Make
sure this place is dry and close to the battery (40cm to 60cm). The electronic control unit can be mounted
vertically on a
side
wall
or
be
mounted
flat.
When mounted
vertically,
the
connections
must
point
downwards
to
avoid
any
short-circuits by objects falling into it.
•
Fix the electronic control unit securely into position with two screws M5x40 (35).
Note:
if the provided screws
are not of suitable length or type for the desired location/material, please substitute these as appropriate. • Drill
a
25mm hole
through the
floor
of
the
caravan approximately
150mm
centrally in
front
of
the
control unit
(32)
terminals.
Caution! Take extra care to avoid any chassis members, gas pipes and electrical wires!
•
Route and connect the motor-cables in accordance with wiring diagram (Fig. 8) (red = positive, black =
negative). The wiring diagram (Fig. 8 + Table. A) below depicts the wiring route when installing the motor units
in front of the wheels/axle
towards the
‘A’
frame. Please refer
to
table
B
(below) for
fitment of
the
motor
units
to
the
rear
of
the
axle.
Table A
Table B
FRONT OF AXLE FITTING
REAR OF AXLE FITTING
Motor A Positive (+) cable to terminal 4
Motor A Positive (+) cable to terminal 1
Motor A Negative (-) cable to terminal 3
Motor A Negative (-) cable to terminal 2
Motor B Positive (+) cable to terminal 2
Motor B Positive (+) cable to terminal 3
