22
CLLIODA600RGB / CLLIODA1000RGB System Settings - terms and explanations
Display
ON
= Display light is permanently on
OFF
= Display light is permanently off
5S
= Display light turns off after 5 seconds of inactivity
15S
= Display light turns off after 15 seconds of inactivity
Master
ON
= Master/Slave mode: DMX signals will be output
OFF
= Master/Slave mode: DMX signals will not be output
Note on the master/slave mode: Master unit: Master ON
Slave unit: 4-CH Mode
Laser
Size 10 - 128
= Setting the maximum size of the laser projection
Colour
= RGB = entire colour spectrum. RGY = red, green and yellow.
InvertX ON
= Movement direction of the X-axis is reversed
InvertX OFF
= Standard movement direction of the X-axis
InvertY ON
= Movement direction of the Y-axis is reversed
InvertY OFF
= Standard movement direction of the Y-axis
TTLMode ON
= Limitation of the projection colours to
red, green, blue, yellow, cyan, magenta, white
TTLMode OFF
= RGB colour mixing (analogue modulation)
Default
= Reset to factory setting
Test Pattern
= Test projection and setting the speed of stepper motors
from 10 Kpps to 30 Kpps (Kilo points per second)
CLLIODA400RGY System Settings menu
Setup
ENTER -> UP/DOWN Display
ENTER -> UP/DOWN ON
OFF
5S
15S
Master
ENTER -> UP/DOWN ON
OFF
Laser
ENTER -> UP/DOWN Size
ENTER -> UP/DOWN Size 10 - 128
InvertX
ENTER -> UP/DOWN ON
OFF
InvertY
ENTER -> UP/DOWN ON
OFF
TTLMode
ENTER -> UP/DOWN ON
OFF
Default
ENTER
Test Pattern
ENTER -> UP/DOWN Scanner 10 - 30KPPS
