22
DEUTSCH
ENGLISH
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEVICE SETTINGS (Settings)
Press MODE to access the main menu (--- Menu ---). Using the UP and DOWN controls, select the
menu item
Settings
(observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with
UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER):
Settings
(device settings)
Display
Reverse
= flip display
On
Display is rotated by 180° (e.g. for
overhead installation)
Off
No rotation of the display
Display
Backlight
= Display lighting
On
Permanently on
Off
Deactivation after approximately 1
minute of inactivity
DMX Fail
= Operational status with
DMX signal fault
Hold
Last command is retained
Blackout
Activates blackout
Emergency
Light
Spotlight changes to colour macro
"Cold White"
Dimmer
Curve
= Dimmer curve
Linear
Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted
at lower DMX values and broadly
adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjust-
ed at lower DMX values and finely
adjusted at higher DMX values
S-curve
Light intensity can be finely adjusted
at lower and higher DMX values and
broadly adjusted at medium DMX
values.
Dimmer
Response
= Dimmer response
LED
Lamp responds abruptly to changes in
DMX value
Halogen
Spotlight behaves like a halogen spot-
light with soft brightness changes
