10
DEUTSCH
ENGLISH
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
OPERATION
NOTES
• As soon as the spotlight is correctly connected to the power supply, “Welcome to Cameo”, the
model designation, and then the software version are displayed in sequence on the display as
part of the startup process. The spotlight is ready for use after this process, and the previously
selected mode will activate.
• Hold down the MODE button for approx. two seconds to directly access the main display from
the lower menu levels. If there is no input within approx. two minutes, the main display is auto-
matically activated. Briefly press MODE to go up one level in the submenus.
• Briefly hold down MODE and ENTER at the same time to directly access the last menu option
used from the main display.
• Starting from the main display, briefly press UP to rotate the display 180°.
• Press and hold UP or DOWN to quickly change a value (e.g., DMX start address).
MAIN DISPLAY DMX MODE
The
DMX Address
and the currently configured DMX start address (e.g., 001) are shown on
the display. If the DMX Delay function is activated, the delay group and the delay time are also
displayed.
MAIN DISPLAY STAND-ALONE MODE
The currently activated stand-alone mode is shown on the display (Mode Direct, Mode CCT, Mode
Loop, Mode Sound).
MAIN DISPLAY SLAVE MODE
Mode Slave
is shown on the display. If the slave unit is assigned to a slave group, the slave
group and delay time set on the master unit in the stand-alone mode
Loop
are also displayed.
CONFIGURING THE DMX START ADDRESS
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now
select the
DMX Address
menu option and press ENTER to confirm your selection. You can now
set the DMX start address as desired using UP and DOWN. Select ENTER to confirm your entry.
