5
DMX
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
4
5
1
2
3
8
6
7
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
1
POWER IN
Neutrik powerCON mains input socket for power supply to the device. A suitable power cable is included.
2
POWER OUT
Neutric powerCON mains output socket for power supply to other CAMEO devices. Ensure that the total current consumption of all connected
devices does not exceed the value specified on the device in amperes (A).
3
FUSE
Fuse holder. Fuse F8AL / 250 V (5 x 20 mm) IMPORTANT: Only replace the fuse with a fuse of the same type and value! In the event of
repeated fuse failure, please contact an authorised service centre.
4
DMX IN
DMX input and output with male 3-pin and 5-pin XLR socket to connect a DMX controller. Always use one connection only for control
purposes – never use both inputs at the same time.
5
DMX THRU
Female 3-pin and 5-pin XLR socket for sending the DMX signal at the DMX input (DMX in). Always use one connection only for sending
purposes – never use both outputs at the same time.
6
DMX
The green LED indicator flashes as soon as a DMX signal is detected at one of the DMX IN sockets: it goes off when the DMX signal is interrupted.
7
PWR
The red LED indicator goes on as soon as the device is correctly connected to the mains power supply.
8
SECURING LUG
For traverse mounting, secure the device to the securing lug using a suitable safety cable.
