35
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
STATUSANZEIGEN
Die Port-Ansicht bietet verschiedene Anzeigen und Text-Infos zum aktuellen Betriebsmodus und Status des selektierten Ports. Die folgenden
Statusinformationen oben links in der Port-Ansicht informieren über den DMX-Signalstatus:
Info-Feld
Port-Modus
Beschreibung
in, out
Kein DMX-Signal.
in, out
Gültiges DMX-Signal erkannt.
out
Keine Aktualisierungen für mindestens 10 Sekunden empfangen, Port gibt zuletzt empfange-
ne Daten aus
1
.
in
Fehler im DMX-Signal erkannt.
Weitere Informationen zum selektierten Port umfassen RDM-Statusanzeigen für Ausgangs-Ports sowie Informationen zum Merge-Modus
und -Status (oben rechts im Display). Diese Statusanzeigen stehen ausschließlich im Art-Net 4- und sACN-Modus zur Verfügung.
Anzeige
Port-Modus
Beschreibung
out
Signal wird aus einer Signalquelle empfangen.
out
Signal wird aus zwei Signalquellen empfangen. Merge-Funktion aktiv.
out
Signal wird aus mehr als zwei Signalquellen empfangen. Siehe Abschnitt „Merge-Modus“.
in
Signal wird an Broadcast- oder Multicast-Adresse gesendet.
Anzeige
Port-Modus
Beschreibung
out
Art-Net RDM ist aktiviert.
out
Merge-Modus ist HTP. Siehe Abschnitt „Merge-Modus“.
out
Merge-Modus ist LTP. Siehe Abschnitt „Merge-Modus“.
NETZWERKEINSTELLUNGEN
Der Zugriff auf die Netzwerkeinstellungen erfolgt über das Menü Home > Menu > Network oder durch zweimaliges Antippen der Ether-
net-Port-Taste.
Darüber hinaus können alle folgenden Einstellungen auch über die Web-Oberfläche (Bereich „Network Settings“) bearbeitet werden.
DHCP
Navigieren Sie zu Home > Menu > Network > DHCP, um DHCP (Dynamic Host Configuration Protocol) zu aktivieren oder deaktivieren.
Wählen Sie „Enable“, wenn Sie Ihr Netzwerk per DHCP-Server konfigurieren lassen möchten. Dies ist typischerweise der Fall, wenn der
XNODE 4 in ein Heim- oder Firmennetzwerk eingebunden ist.
Die jeweils aktive Einstellung ist durch einen Punkt neben dem entsprechenden Menüeintrag gekennzeichnet. Über das Encoder-Rad
können Sie die gewünschte Einstellung auswählen und mit [OK] bestätigen.
•
1
6 Sekunden für Firmware-Version bis 0.93