9
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
STATUS INDICATION
There are several indicators and labels on the Port Screen to show the current operating mode and the state of the selected port. The
following status labels displayed on the upper left of the Port Screen show the DMX signal status:
Label
Port Mode
Description
in, out
No DMX signal present.
in, out
A valid DMX signal is detected.
out
Port is outputting a look which has been received before, but no updates have been received
for at least 10 seconds
1
.
in
An error on the DMX signal appeared.
To show additional information about the selected port, there are status indicators for the presence of RDM on output ports, as well as the
merge mode and status on the upper right of the display. These status indicators are only available with Art-Net 4 and sACN.
Indicator
Port Mode
Description
out
Receiving signal from one source.
out
Receiving signal from two sources. Merger active.
out
Receiving signal from more than two sources. See section Merge Mode.
in
Sending signal to broadcast or multicast address.
Indicator
Port Mode
Description
out
Art-Net RDM is enabled.
out
Merger mode is HTP. See section Merge Mode.
out
Merger mode is LTP. See section Merge Mode.
NETWORK SETTINGS
The network settings can be found under Home > Menu > Network or by double tapping the Ethernet port button.
All following settings can also be changed via web interface on the Network Settings Page.
DHCP
Navigate to Home > Menu > Network > DHCP in order to enable or disable DHCP (Dynamic Host Configuration Protocol). Choose Enable
if you want to have your network configured by a DHCP server. This would typically be the case if you connect the XNODE 4 to a home or
office network.
A bullet point is shown next to the currently active setting. Use the encoder wheel to choose the desired setting and confirm by pressing
[OK] in order to change the setting.
•
1
6 seconds for firmware version 0.93 and earlier
