User
Guide
Page 56
Basic Installation for Local and Remote Monitoring
11.b.8.
Press
[Connect]
icon to connect your
PC and the video recording server. The video
appears on the WX-30 if success. Otherwise, the
[Warning]
board will pop up and show you
failure message. For failure case, please press
[Connect]
icon to check that the connection
setting is valid or not.
11.b.9.
Press
[Transmitter setup]
icon to show
RX
configuration menu.
11.b.10.
Select
[Connection]
and press
[Modem
Settings]
icon to configure
network setting.
11.b.11.
Assign modem baud rate in order to adjust
modem connection speed.
11.b.12.
Assign ring count, so modem can connect to the
video recording server after that ring count.
11.b.13.
Press
[Apply]
icon to save the
network setting and the message board will pop
up. After several seconds, the video recording
server will restart automatically.
12.
If user setup modem connection by using local CCTV monitor (Step 11a), please install the
modem for your PC and connect to the telephone network in order to connect to
RX
video recording server
