User
Guide
Page 51
Basic Installation for Local and Remote Monitoring
Setup Procedure
1.
Connect cameras to
RX
{Video Input}
with RG59 cable and BNC connector.
Note: The camera system is either
NTSC
or
PAL
and all cameras must have the SAME
system format.
2.
Connect CCTV monitor to
RX
{Video Output}
with RG59 cable and BNC
connector.
3.
Install and use the bundled key to lock the
{Hard Disk Rack}
with hard disk to the
RX
.
Note: If there is no hard disk installed, Recording or Playback is not functional during live
video monitoring.
4.
Connect the power adapter (12V DC) to the
RX
.
5.
Turn on the power of
RX
, camera and monitor. Check the
{Power LED}
,
which is lit up in blue color continuously at
RX
front panel after power on.
After several seconds, live video appears on the CCTV monitor as follows:
Note: Please go through the following steps (6-10) if the video of CCTV monitor does not show
clearly.
