![background image](http://html.mh-extra.com/html/camfil/cleanseal-exhaust-v3/cleanseal-exhaust-v3_installation-and-operating-manual_487856058.webp)
EMC_SPEC040_CLCR.doc
Rev. E
–
2021 10 18
58/63
Install & Operating Manual
CleanSeal V3
MIP Driver
The Camfil MIP Driver is designed to enable simple operation in
a wide range of stable scanning speeds while preserving
the drive mechanism.
Power Supply is delivered from a main adapter or alternatively
by a optional portable battery pack.
User Interface
:
Display and Buttons
1.
Temperature (maximum from motor and driving circuit) is linearly visualized
from 15°C (0 bars) to 60°C (14 bars)
2.
Torque is linearly visualized from 0 Nm (0 bars) to 0,6 Nm (14 bars)
3.
a) Preset RPM is visualized as 100 x (bar count + 1). When running actual RPM is highlighted
b) Numeric value of the preset RPM value
4.
Spindle rotation direction as seen from the back (operator's view)
5.
Error code (shared position with rotation direction)
6.
Decrease RPM by 100 - adjustable on the run
7.
Increase RPM by 100 - adjustable on the run
8.
Change rotation direction - only when stopped
9.
Run
Operation
1.
Set desired rotation speed by using Increase (7) and Decrease (6) RPM buttons.
2.
Set desired rotation direction by using button for direction change (8)
3.
Start motor operation by pressing run button (9). To stop motor operation, release Run button.
4.
Any error code will stop the motor. To reset, press Run button (9) or Direction button (8).