PM 1000288 000 00
Device handbook SIRAX BT5100
21/32
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
O/P 1
A
O/P 1
A
*
O/P 1
A
*
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
O/P 1
A
O/P 1
A
*
Enter New / Change Start value of the Output 1, second digit entered, prompting for third digit. (*Denotes that
digit will be fl ashing).
Pressing the “
Down” key will scroll the value of the third digit from 0 through to 9, the value will wrap
from 9 round to 0 depending on the set End value of Output.
Pressing the “
Up” key will advance the operation to the next digit and set the third digit, in this case to
“0”.
Enter New / Change Start value of the Output 1, third digit entered, prompting for fourth digit. (* denotes that
digit will be fl ashing).
Pressing the “
Down” key will scroll the value of the fourth digit from 0 through to 9, the value will wrap
from 9 round to 0 depending on the set End value of Output.
Pressing the “
Up” key will advance the operation to the “New / Changed Start value of the Output 1” and
set the fourth digit, in this case to “0”.
New/changed Start value of the Output 1 confi rmed.
Pressing the “
Down” key will re-enter to the “New / Change Start value of the Output 1”.
Pressing the “
Up” key will confi rm New Start value of the Output 1 and advance to the selection of Elbow
value of Output (section 7.1.6.1.3) or Output 2 parameter selection (section 7.1.6.2)
Pressing the “
Down” key will enter the “ New/Change Elbow value of the Output 1edit” mode.
Pressing “
Up” key will set the present value as Elbow value of the Output 1 and advance to the Output 2
parameter selection (section 7.1.6.2).
New / Change Elbow value of the Output 1
(*Denotes that digit will be fl ashing).
Pressing the “
Down” key will scroll the value of the fi rst digit from 0 through to 2, the value will wrap
from 2 round to 0 depending on the set End value of Output.
Pressing the “
Up” key will advance the operation to the next digit and set the fi rst digit, in this case to
“1”.
7.1.6.1.3 Elbow value of output 1
This screen appears only when Elbow function is enabled.
This screen allows the user to set the Elbow value of Output 1 (considerd as DC Current). The Elbow value can be set any value between set Start
value of Output and End value of Output.
