04
Installation and Management
Caution
Before use the product, check if operation and video recording goes well.
Installation and Management
•
Keep clean the camera lens by preventing dust or foreign substance from getting in the lens part.
Otherwise, it may result in video distortion. If another object is placed around, it can be reflected from the window.
So do not put another object around the installed product.
•
If installation location of the product is changed, it may not record properly even if it worked after initial installation.
Therefore, install the product firmly and do not give an excessive shock or force to move the product.
•
Continuous change of product location from the windshield may cause weakening of adhesive strength and the product
can fall off in the end.
•
Before insert SD card into the product, check the location of SD card is correct.
•
In case of using the power from the vehicle (DC fuse power), please disconnect the power cable from the product
if you do not use the product for a long time.
(It may cause discharge the battery.)
•
Do not power off while firmware is under upgrade. it may cause malfunctioning.
•
Long time use of product or in case of severe vibration by driving unpaved road may cause change angle or location
of product. Correct the angle or location of product properly in a flat road after pull over to the side of the road.
•
Do not use chemicals or detergents to clean the product. This can result in malfunctioning of the product.
•
Never give an excessive shock to or inject a foreign substance into the product. Give an excessive force or shock
or injecting a foreign substance into this product can cause a trouble.
•
Avoid high temperature(direct sunlight) or high humidity for the normal operation of product.
•
Do not disassemble or remodel this product. It can cause an accident due to malfunctioning
and such action will result in the product being unfit for use and void all warranty/service provisions.
Summary of Contents for BLACKSYS CF-100
Page 31: ...MEMO...