Fastening the first board and last board
: Secure the first board along the house or at the outside
of the deck. By face fastening with the appropriate screw for the deck material at each joist.
FOR USE WITH ANY ANGLED DECKING PATTERN
1. On the outside edge
of your installed starter
board, simply pinch the
"wings" of EDGEXCLIP
™
together and slide the clip
into the groove.
2. Place EDGEXCLIP
™
at every joist along the
length of the board.
3. You are now ready to
slide your next board up
against EDGEXCLIPS
between the two boards.
4. Holding the new board
tightly in place, screw
down all of clips between
the board.
Use the yellow
Never-Miss™ Guide
(
shown here) included, to
perfectly engage the
driver bit with the screw
head for fastest
installation.
5. Follow the same
process for each deck
board.
The "wings"of the clip will
expand, holding the clip
in place.
NO NEED TO PRE-SET
SCREW INTO JOIST.