OPERATION
Procedure for Cutting a Stump
(continued)
3.
Cut stump proper
!
Make sure the throttle is set to “FAST”. The cutter
wheel is thus accelerated to cutting speed.
!
Direct the cutter wheel against the stump, beginning
with the nearside top corner of the stump, and
steadily sweep it across the stump left and right,
1
cutting away / “ of wood with each sweep.
2
!
Raise and lower the cutter wheel, between sweeps as
needed, by lowering and raising the control handle.
!
Roll the machine forward and back, by pushing and pulling on the control handle, between sweeps as
needed, in order to progress into the stump. To do this, release the brake. Re-lock it when the machine
has been repositioned, and continue cutting.
4.
Continue with final roots removal
!
Cut the remaining roots as described in STEP 2 until
satisfactorily removed.
5.
Shut off the engine by releasing the operator presence lever.
C500 Stump Grinder
C500/0704/OP/5
