Camon SP5EN, Operating Instructions Manual

SP5EN Log Splitter

Page 14 

SP5EN/1212

Use

DO NOT USE THE MACHINE OUTDOORS WHEN IT IS RAINING OR 
SNOWING.

Switching the Log Splitter on/off

Connect the Log Splitter to the power supply.

Never pass the power cable over the log pusher, close to the wedge or anywhere where it may be 
damaged or severed.

3RVLWLRQWKHORJRQWKHEHDPDVVKRZQLQ¿JSDJH7KHVXSSRUWLQJJXLGHVQR¿JSDJH

3) help to keep the log at the centre of the wedge.

,IWKHORJWHQGVWRZREEOHLWPXVWEHUHSRVLWLRQHGWXUQLQJLWVRWKDWLVUHPDLQV¿UPO\RQWKHEHDP

With your right hand, 

THOROUGHLY

 press the starter button of the electric motor (1), and with 

\RXUOHIWKDQGSUHVVWKHFRQWUROOHYHUDOOWKHZD\GRZQDVVKRZQLQ¿JRQSDJH7KHORJ

pusher will go into action and split the log.

Warning: the button must be pressed thorougly in order to avoid burning of the inside 
contacts.

Repeat the operation with the pieces obtained so as to split the log into several parts.

Never force the Log Splitter for more than a few seconds keeping the cylinder under 
pressure ¡n the attempt to split excessively hard wood.  Under pressure, the oil will 
overheat and the machine could be damaged.  It is thus better to stop and rotate the 
log by 90

o

 to see whether it can be split in a different position.  In any case, if you 

are not able to split the log, this means that its hardness exceeds the capacity of the 
machine and so that log should be discarded so as not to damage the Log Splitter.

On completing the work, pull the plug. Never yank the plug using the cable. Grasp the body of the 

SOXJDQGSXOOLW¿UPO\

When not in use, store the machine where it is protected from atmospheric agents.

When transporting (e.g. loaded on motor vehicles), ensure that all parts of the machine have 
cooled down completely, and that the bleeder screw is screwed tight, and the machine is positioned 
horizontally.

!