Camon SP7E, Operating Instructions Manual

SP7E Log Splitter

Page 14 

SP7E/0612

This chapter describes routine maintenance, i.e. operations carried out by the operator, on the SP7E 
Log Splitter to keep it in perfect working order and therefore reliable for continuous, long-term use.

All routine maintenance operations must be carried out with the machine off and in the case of log 
splitters with electric motor with the power cable disconnected.

$Q\RWKHUPDLQWHQDQFHRSHUDWLRQQRWVSHFL¿FDOO\RXWOLQHGLQWKLVPDQXDOPXVWEHFDUULHGRXWE\

authorised personnel as a hazardous situation may arise for which the operator is not prepared.

Where extraordinary maintenance or part replacement operations are not carried out by authorised 
personnel, the guarantee shall be immediately null and void and the supplier shall be relieved of any 
responsibility for injury to persons or animals or damage.

How to change the hydraulic oil

The spent oil must be replaced with new oil of the type indicated on page 8 every 400 hours of 
operation. To change the oil, proceed as follows (see also diagram on page 5).

Make sure that the log pusher of the machine is fully retracted.

8QVFUHZWKHFDSVKRZQLQ¿J$RQSDJHDQGUHPRYHLWFRPSOHWHO\

Position a container under the Log Splitter that can hold 8 litres of oil; then tilt the machine to empty 

WKHRLO¿J%SDJH

7LOWWKHPDFKLQHLQWKHRWKHUGLUHFWLRQ¿J&SDJHDQGSRXULQOLWUHVRIRLORIRQHRIWKHW\SHV

indicated on page 8.

&OHDQWKHGLSVWLFNDQGLQVHUWLW¿J'SDJHWRFKHFNWKDWWKHRLOOHYHOLVEHWZHHQWKHWZR

notches on the stem.

Clean the cap and washer thoroughly and re-tighten completely but carefully so as not to break the 
threading of the cap.

WARNING:  NEVER MIX OIL WITH GENERAL WASTE!  USED OIL MUST BE 
DISPOSED OF ACCORDING TO CURRENT REGULATIONS IN THE COUNTRY 
WHERE THE MACHINE IS USED.

Routine Maintenance

!