Camos DVWS-100, Instruction Manual

9

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio communica-
tions.
However, there is no guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off  and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:

_Reorient or relocate the receiving antenna.
_Increase the separation between the equipment and receiver.
_ Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is 

connected.

_Consult the dealer or an experienced radio/TV technician for help.

Caution : Changes or modifi cations not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equipment.

IMPORTANT NOTE : To comply with FCC RF exposure compliance requirements, the antenna used 
for this transmitter must be installed to provide a separation distance of at least 20 cm from 
all persons and must not be co-located or operating in conjunction with any other antenna or 
transmitter.