Direction of motion
Cable entry box
3. Installation Planning
Decide where you wish to mount your satellite system.
Location of the lift assembly must allow antenna to point towards the
rear of the vehicle when resting in the travel position, and must clear all
roof mounted equipment when being raised, lowered or rotated.
The inside ceiling must be clear of obstructions to ceiling plate and
handle. Before drilling, check for cables or obstructions within the roof
space.
Tape the drill template to the roof of the vehicle in the position where
the lift assembly will be installed. Mark the centre hole as well as
mounting holes.
Ensure that the lift assembly is located in front of
the antenna pointing in direction of motion.
The roof perforation for antenna cable should be located approx. 13 cm
in front of lift assembly (in direction of motion).
Also, check for cables, equipment, or obstructions inside the vehicle
before drilling.
Select the location and drill one 13 mm diameter hole through the roof
only for the coaxial cable.
10-13cm
cable feedthrough
