Pag. 26
Use and maintenance manual – Translation of
original Instruction.: 03, Date 11/03/2021
Each recharge connector (7) has a corresponding indicator on the battery charger.
The batteries are charged in sequence, the one after the other, not simultaneously.
Charge with 3 batteries: Picture 1 = Recharge in progress
Picture 1
Picture 3 = Recharge completed
Picture 3
Important: When two or three batteries are connected to the battery charger, they will be charged in sequence, start-
ing from no. 1, then no. 2 and at the end no. 3. The LED light becomes red during the recharge, green when recharge
is over.
As soon as the first battery is charged up (green LED light), the recharge of the second battery will start, then it will
start the recharge of the third one, if they are all connected to the battery charger.
WARNING!
During long periods of inactivity of the shear, it is recommended to charge the battery every 3 months, so as
not to compromise its lifespan.
WARNING!
Use only the charger supplied with the shear. A different one with other specifications could cause fires.
4.2.1 Warnings during and after the charge
•
While recharging the charger and the battery become warm.
•
To make a battery reach its maximum capacity, about 5 charging and discharging cycles are necessary if it is new
battery or if it has not been used for a long period.
•
Do not charge the batter at a room temperature below 0°C (32°F) or above 45°C (113°F).
•
Do not recharge a previously charged battery after few minutes of use, so as not to reduce its performance.
•
Do not use a damaged battery.
•
Do not disassemble either the battery or the battery charger.
•
When the battery is not assembled on the shear, keep it away from conductive metal objects, in order to avoid short
circuit risks.
•
Do not cause a short circuit of the battery.
•
Do not store the battery near heat sources, indoors or in a potentially explosive atmoshere. The battery could
explode or generate a fire.
•
Do not charge the battery in damp rooms or outdoors.
•
Do not use or charge the battery close to heat sources or in the direct sunlight.
•
When the battery charge decreases, the shear cutting performance decreases as well
•
Do not leave the battery in the rain and store it in a dry place.
•
Do not put the shear, the battery or the charger into any liquids.
•
Do not insert nails, do not hammer or step on or throw or cause any other damage to the battery.
•
Do not carry out welding on the battery.
•
Do not reverse the polarity of the connections or excessively discharge the battery.
•
Do not connect the battery to car chargers or cigarette lighter sockets.
•
Do not use the battery for devices which are other than those indicated by the Manufacturer.
•
Do not come into direct contact with lithium battery cells.
•
Do not put the battery into microwaves or containers with high temperatures or high pressures.
•
Do not use the battery in case of fluid loss.
•
Do not use the battery in an electrostatic environment (above 64V)
•
Do not use the battery if it is corroded, visibly deformed or unpleasantly smelly.
•
If your skin or clothes come in contact with the battery fluid, rinse them immediately with water.
•
Keep the battery fully charged when the shear is not used for long periods.
•
Always disconnect the charger from the electrical network when the batteries are charged up.
Summary of Contents for LN24.0200
Page 2: ......
