Campagnola Srl
– USE AND MAINTENANCE MANUAL – Traslation of the original Instructions
Ver.1.0 - Rev.: 00, Data: 20/10/2016
Pag.24
WARNING!
• As soon as the engine starts working, the tool produces harmful exhaust gas, which can be odourless and
invisible.
• Do not use the tool indoor or in scarcely airy rooms.
5.5 Extension pole and tool assembly
5.5.1 Extension pole assembly
Carry out the following operations:
a) Insert the
joint (12) (picture F) into the shaft.
b)
Insert the extension pole (13) (picture. G).
c)
Tighten the screw (14) (picture G).
5.5.2 Harvesting head assembly
Carry out the following operations:
a)
Insert the joint (12) (picture H) into the shaft.
b)
Insert the harvesting head into the extension pole (13) (picture I).
c)
Tighten the screws (14) (picture I).
5.6 Troubleshooting
WARNING!
All special maintenance operations shall be carried out only by well-trained personnel.
FAULTS
CAUSE
REMEDY
The engine does not start.
•
Missing fuel.
•
The pre-starting procedures have not
been carried out properly.
•
Add fuel.
•
Check the engine manual.
Overheating comes out of the gearbox.
•
Missing lubrication.
•
Worn-out component.
•
Take the tool to an Authorized Service
Point.
The harvesting head does not move.
•
The extension pole has not been in-
serted properly.
•
Check the extension pole and the trans-
mission joints for proper positioning.
NOTE: If the indicated remedies do not solve the problems, take the unit to an Authorized Service Point.
