5
6
4.2.2
- DISASSEMBLY
C
E
APRIRE
OPEN
ÖFFNEN
UT-CS060
B
UT-BB080
F
G
E
B
F
UT-BB080
UT-CS060
OPEN
1)
Remove the lockring (G - Fig. 5) using the
Campagnolo
®
tool UT-BB080 (B - Fig. 5) with a 24
mm hexagonal wrench (E - Fig. 5) and the chain
whip Campagnolo
®
UT-CS060 (F - Fig. 5).
2)
Insert the plastic sprocket carrier on the side of
the freewheel body and align the spline patterns
on the body with those on the carrier. Slide the
sprockets onto the carrier.
3)
Slide the sprockets, off the freewheel body (Fig.
6).
IMPORTANT!
WITH THE 11S FREEWHEEL BODY, ONLY USE THE ADAPTER (M - FIG.7) FOR 9S AND 10S SPROCKET
PACKS BY SHIMANO INC. AND SRAM CO. (THE ADAPTER MUST NOT BE USED FOR 11S SPROCKET
PACKS BY SHIMANO INC.).
The adapter (M - Fig.7) must be fitted on the freewheel body of the 9s or 10s sprocket pack, or on any
washer supplied together with the 9s or 10s sprocket pack.
See the instruction sheet provided by the sprocket pack manufacturer for installation, removal and main-
tenance instructions.
M
7
4.3 - 9S, 10S, 11S SPROCKETS FROM SHIMANO INC. and SPROCKETS FROM SRAM CORPORATION
(on the Campagnolo
®
freewheel body for Shimano Inc. 9/10/11s sprockets and sprockets)
ENG
7
