ERGOPOWER CONTROL LEVERS - Rev. 00/ 07-2022
CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL
10
• Please make sure that the cable is flowing freely within
the sheath. Verify in particular that the sheath head entries
are rectilinear (Fig. 17), to avoid hindrances to the gear-
shifting system.
• If the sheath is too short, the shift function will be affected
(Fig.17).
- Lift up the hood and push the end of the 680 mm long, 4.1
mm diameter housing into the hole provided (Fig. 1).
- Slightly bend the cable (for the first 5 – 10 mm) (Fig. 18) to
facilitate insertion of the same into the sheath.
• Move the control to the smallest chainring position.
4.1.2 - FRONT DERAILLEUR CABLE AND HOUSING (WHERE APPLICABLE)
WARNING!
After installation, check that the cables do not interfere with your steering or any other function of your bicycle. Interference could affect your
ability to turn or control your bicycle, resulting in an accident, personal injury or death.
Insert the front derailleur cable (length 1,600 mm - ø 1.2 mm)
into the bottom of the control (B – Fig. 19)
WARNING!
Before cutting out the housing, please be careful to make
sure that the chosen length is suitable for the size of your
frame. An insufficient length may cause too straight curves
and will prevent the transmission from functioning properly
(Fig. 20).
17
B
A
18
Park Tool CN-10
20
B
19
