ERGOPOWER CONTROL LEVERS - Rev. 00/ 07-2022
CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL
7
• Fold back the rear of the hood (A - Fig. 1) to expose the
securing screw (B - Fig. 1).
• Loosen the bolt (B - Fig. 1) positioned in the top of the
body sufficiently to fit the clamp (C - Fig. 2) on the untaped
handlebar.
Make sure that the arrow on the band faces towards the
upper part of the control unit (C - Fig. 2).
• If the hood has been completely removed, moisten the
inside slightly with alcohol to facilitate installation on the
control unit.
1
• Position the Ergopower™ control in the curved area of
the handlebar and attempt to create a straight line if the
handlebar bend lets you (Fig. 3).
C
- The control unit must be correctly oriented to avoid affec-
ting bicycle aerodynamics (Fig. 4)
• Secure the control on to the handlebar by tightening the
screw (B - Fig. 1) to 10 Nm (89 in.lbs) using a torque wrench.
A
B
4 - ASSEMBLY
2
3
NO!
SÌ!
NO!
4
NO!
NO!
OK!
4.1 - ASSEMBLY OF TRANSMISSIONS (MECHANICAL UNITS)
• Install the cable guide plate under the bottom bracket
shell, as follows:
- position the washer (A – Fig. 5) in the provided seat in the
cable guide plate.
- place the cable guide plate under the bottom bracket shell
and fix it by means of the provided screw (B – Fig. 5) with a
torque of
3÷4 Nm (27÷35 in.lbs).
Different plates can also give rise to a serious loss of per-
formance.
B
A
5
6
• The cable housings of the rear derailleur (Fig. 6) have a
diameter of 4.1 mm, while the brake cable housings (Fig.6)
have a diameter of 4,9 mm.
NOTE
Use only ‘maximum smoothness’ cables and sheaths with
these Ergopower commands.
