ERGOPOWER CONTROL LEVERS - Rev. 00/ 07-2022
CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL
8
• Depending on your frame, it may be necessary to cut the
rear brake housing and install a housings end (not supplied
in your Ergopower™ control levers package). and install a
casing lead end (not supplied in your Ergopower™ control
levers package).
NOTES
The housing must be cut so that the end is perpendicular to
the length (Fig. 7). In addition, the cross section of the hou-
sing must not change. After cutting the housing, check that
you have restored its roundness to ensure that there is no
friction between the cable and housing.
To cut the casings, we suggest you to use the specific tool
Park Tool CN-10.
Insert the end of the housing into the provided slot in the
body of the control (Fig. 8). Ensure that the housing rests
perfectly on the bushing fixed on the body.
• Attach the housing to the Ergopower™ control lever as
illustrated. The rear derailleur (or front derailleur) housing
(A - Fig. 9) should be positioned in the outer slot of the con-
trol unit; the brake housing (B - Fig. 9) should be positioned
in the inner slot of the Ergopower™ control lever unit.
• If you prefer, you can pass the derailleur cable housing
alongside the brake casing, as shown in figure 10.
CAUTION
Position the cable so that it is as straight as possible. At all
costs avoid kinks or sharp bends in the housing (less than
R = 50 mm).
R = 50 mm
B
A
A
B
Park Tool CN-10
WARNING!
After installation, check that the cables do not interfere
with your steering or any other function of your bicycle.
Interference could affect your ability to turn or control your
bicycle, resulting in an accident, personal injury or death.
WARNING!
Before cutting the housing, carefully check that the length
you choose is suitable for the dimensions of your frame.
Insufficient slack in the cable and housing could affect your
ability to turn or control your bicycle, resulting in an accident
personal injury or death.
7
8
10
9
