FT-136 Birds Element Fountain
Revised April 10, 2017
Assemble your fountain on a level surface capable of holding a minimum of 153 pounds with
an approximate 1.25 square foot footprint.
FT-135C (66 lbs)
18”L x 10”W x 8”H
FT-136A (69 lbs)
5”L x 10”W x 22.75”H
FT-135B (6 lbs)
6.5”L x 6.75”W x 4”H
1.
Position the basin (FT-135C) where the fountain is to be
installed, ensuring that it is level.
2.
Assemble the pump kit
a.
Using a hose clamp, attach the 1/2" non-kink tubing
to the pump outlet.
3.
Place the pump in the basin (FT-135C) next to the gap on
the top lip.
4.
Lay the pump cord in the lip at the top of the basin (FT-
135C).
5.
Insert the 2 rebar support pipes into the holes at the back of
the basin
6.
Place the water feature (FT-136A) over the rebar support
pipes.
a.
Check that the water feature (FT-136A) and basin
(FT-135C) rest flush.
b.
Check that the pump chord is not being crushed.
7.
Fit the 5/8” clear tubing over the CPVC pipe protruding
from the bottom of the water feature (FT-136A).
8.
Place the pump cover (FT-135B) in front of the pump
assembly and push back until properly seated.
a.
Cover should be placed with the finger hole to the
bottom.
b.
Note: If cover is not installed properly, it will not fit
in the basin.
9.
Fill the fountain with water.