FT-150 Low Zen Sphere Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 421 lbs with an
approximate 3 sq. ft. footprint (actual dimensions 37.5" x 37.5").
Step 1 - Position the basin (P-505) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the fountain plumbing:
2a - Attach the 5/8" clear tubing to the pump outlet.
2b - Place the stopper around the pump cord approximately 8" from the pump.
Step 3 - Feed the pump cord all the way through the hole in the basin and run the cord through the
channel in the bottom to ensure the fountain will be level.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper in
place.
P-505 (285 lbs)
39.5"W x 10"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
FT-150B (15 lbs)
11"W x 5.75"H
FT-150A (121 lbs)
12.5"W x 14"H
Step 5 - Place the pump cover (FT-150B) over the pump. Ensure it is placed properly and leveled.
Step 6 - Position the water feature (FT-150A) on top of the pump cover.
Step 7 - Insert the loose end of the tubing into the hole at the bottom of the water feature
(FT-150A).
Step 8 - Ensure the water feature is centered and leveled on the pump cover.
Step 9 - Place the pump cover door (FT-150C) in the pump accesss opening of the pump cover
(FT-150B).
Step 10 - Fill the fountain with water.
FT-150C (3 lbs)
6"L x 1.5"W x 3.75"H
