FT-221 Jensen Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 90 lbs with an
approximate 1 sq. ft. footprint (actual dimensions 13" x 10").
Step 1 - Position the basin (FT-221C) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attach the 1/2" non-kink tubing to the pump outlet.
2b - Place the stopper around the pump cord approximately 6" from the pump.
Step 3 - Feed the pump cord through the hole and channel in the basin (FT-221C).
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
FT-221C (65 lbs)
25.75"L x 18.25"W x 11"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 5 - Position the pedestal with bowl (FT-221B) over the basin (FT-221C).
Step 6 - Fit the clear end of the tubing assembly to the pipe protruding from the bottom of the
pedestal with bowl (FT-221B).
Step 7 - Center and level the pedestal with bowl (FT-221B).
Step 8 - Using the silicone provided, place the copper spillers.
8a - Clean away any excess silicone.
Step 9 - Fit the finial (FT-221A) into the pedestal with bowl (FT-221B) by pushing the protruding
CPVC pipe from the finial into the CPVC coupling on the bowl.
Step 10 - Let the fountain sit 24 hours before filling with water.
FT-221B (16 lbs)
14.5"L x 9.75"W x 9.5"H
FT-221A (1 lbs)
4.25"L x 3"W x 4.75"H
