Campbell Hausfeld Cast Iron Series Operating Instructions Manual Download

Page: 1 / 24

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.

Air compressor units are intended to
provide compressed air to power pneu-
matic tools, operate spray guns and sup-
ply air for pneumatic valves and actua-
tors. The pumps supplied with these
units have oil lubricated bearings. A
small amount of oil carryover is present
in the compressed air stream.
Applications requiring air free of oil
vapor should have the appropriate filter
installed. The air compressor units are to
be mounted per the instructions provid-
ed on a solid floor. Any other use of
these units will void the warranty and
the manufacturer will not be responsi-
ble for problems or damages resulting
from such misuse. Refer to the enclosed
“Replacement Parts Manual” to identify
compressor as single stage or two-stage.

Safety Guidelines

This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROB-
LEMS. To help recognize this informa-
tion, observe the following symbols.

Danger indicates
an imminently haz-

ardous situation which, if not avoided,
will result in death or serious injury.

Warning indicates
a potentially haz-

ardous situation which, if not avoided,
could result in death or serious injury.

Caution indicates a
potentially haz-

ardous situation which, if not avoided,
MAY result in minor or moderate
injury.

Notice indicates

important informa-

tion, that if not followed, may cause
damage to equipment.

NOTICE

Operating Instructions

Cast Iron Series

Breathable Air Warning

This compressor/pump is NOT
equipped and should NOT be used
“as is” to supply breathing quality
air. For any application of air for
human consumption, you must fit
the air compressor/pump with suit-
able in-line safety and alarm equip-
ment. This additional equipment is
necessary to properly filter and puri-
fy the air to meet minimal specifica-
tions for Grade D breathing as
described in Compressed Gas
Association Commodity
Specification G 7.1 - 1966, OSHA 29
CFR 1910. 134, and/or Canadian
Standards Associations (CSA).

DISCLAIMER OF WARRANTIES

In the event the compressor is used
for the purpose of breathing air
application and proper in-line safety
and alarm equipment is not simulta-
neously used, existing warranties
are void, and Campbell Hausfeld dis-
claims any liability whatsoever for
any loss, personal injury or damage.

Unpacking

After unpacking the unit, inspect care-
fully for any damage that may have
occurred during transit. Make sure to
tighten fittings, bolts, etc., before
putting unit into service.

Do not operate
unit if damaged

during shipping, handling or use.
Damage may result in bursting and
cause injury or property damage.

Since the air compressor and other
components (material pump, spray
guns, filters, lubricators, hoses, etc.)
used make up a high pressure pump-
ing system, the following safety pre-
cautions must be observed at all times:

1. Read all manuals

included with this
product carefully.
Be thoroughly
familiar with the
controls and the proper use of
the equipment.

2. Follow all local electrical and safety

codes as well as the United States
National Electrical Codes (NEC) and
Occupational Safety and Health Act
(OSHA).

3. Only persons well acquainted with

these rules of safe operation should
be allowed to use the compressor.

4. Keep visitors away and NEVER

allow children in the work area.

5. Wear safety glasses and use

hearing protection when operating
the unit.

6. Do not stand on or use the unit as

a handhold.