9
Step 2 – Using Your
HousePainter
(Cont.)
much as possible. If you still have
‘tails’ at the highest pressure setting,
or if you have any other pattern prob-
lems, please see the suggestions in the
Troubleshooting chart beginning on
page 13.
Spraying
Position yourself so the spray tip is
10” – 12” from the surface being
sprayed. It is important to keep your
knuckles pointed at that surface to
make sure you only spray the intended
surface.
Begin moving the gun, then pull the
trigger. Hold the trigger throughout a
comfortable range of motion and
release the trigger prior to changing
direction or ending the stroke. In other
words, try not to activate or release
the trigger when your arm is not in
motion. You will get a build up of
paint at any point where the gun is
spraying without your arm being in
motion.
Rolling
If you use either of the roller acces-
sories available, remove the spray tip
base from the spray gun. Screw the
roller attachment onto the spray gun
(see Figure 10).
Prime the sprayer as described on Page
8. When bubbles are no longer visible
in the bypass tube, turn the One Touch
Control to the Roller icon (see Figure
12). Use the gun trigger to load the
EZ5000 Series
www.chpower.com
Figure 19 – Paint beginning to dot
roller cover
12”
Holding Spray Gun
Thin Coat
Thin Coat
Heavy
Coat
Over-
spray
Over-
spray
Result of Flexing Wrist While Spraying
INCORRECT
Approx.
10-12”
Start
Stroke
Pull
Trigger
Release
Trigger
End
Stroke
Proper Way to Trigger Spray Gun
Summary of Contents for HousePainter EZ5000 Series
Page 18: ......
