2
Operating Instructions and Parts Manual
www.campbellhausfeld.com
general safety
Danger means a hazard that will cause
death or serious injury if the warning is
ignored.
Warning means a hazard that could cause
death or serious injury if the warning is
ignored.
Caution means a hazard that may cause
minor or moderate injury if the warning is
ignored. It also may mean a hazard that will only cause damage
to property.
note:
Note means any additional information pertaining to
the product or its proper usage.
Read all instructions and safety precautions before operating
the unit.
califoRnia pRoposition 65
This product or its power cord may contain
chemicals, including lead, known to the
State of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
geneRal safety
Risk of fire or explosion! Solvent and paint fumes
can explode or ignite,causing severe injury and
property damage.
Paints and solvents containing HALOGENATED
HYDROCARBONS can react explosively with
aluminum. Always check the product’s label before using these
materials in the unit.
Make sure the room is well-ventilated.
Avoid all ignition sources, such as static electricity sparks, open
flames, hot objects, sparks from connecting and disconnecting
power cords, and working light switches.
Follow the material and solvent manufacturers’ safety
precautions and warnings. Do not use liquids with flash points
less than 100 degrees Fahrenheit (38 degrees Celsius).
Do not carry TURBINE while spraying.
Keep the turbine at the maximum distance from the spraying
area.
Static electricity can be produced by HVLP spraying. Make sure
any electrically conductive object being sprayed is grounded to
prevent static sparking. The sprayer is grounded through the
electric cord. If an extension cord is necessary, the cord must be
a grounded, 115 volt, three wire type cord.
Hazardous vapors: Paints, solvents, insecticides, and
other materials may be harmful if inhaled, causing
severe nausea, fainting, or poisoning.
Use a respirator or mask whenever there is a chance
that vapors may be inhaled. Read all instructions
with the mask to ensure that the mask will provide the
necessary protection against the inhalation of harmful vapors.
NEVER point the spray gun at any part of the body, or at
anyone else.
Tipping the gun causes the gun to clog. Dried spray material
also clogs the pressure delivery tube and fittings. The spray
gun does not function when clogging occurs.
When not in use, be sure to disconnect the hose and place the
gun on a solid, level surface to avoid tipping.
gRounding instRuctions
This product must be properly grounded. In the event of an
electrical short circuit, grounding reduces the risk of electrical
shock by providing an alternate path for the electrical current.
This product is equipped with a cord that has a ground wire
and an appropriate ground plug. Plug the unit into an outlet
that is properly installed and grounded in accordance with
local codes and ordinances.
Improper installation of the
ground plug can result in the
risk of electrical shock. If repair or replacement of
the plug or cord is necessary, do not connect the
ground wire to either flat blade terminal. The wire
with green insulation (with or without a yellow stripe) is the
grounding wire.
1. For any question regarding proper installation of the ground
plug, consult a qualified (licensed or certified) electrician.
2. Do not modify the plug provided. If the plug does not fit
the outlet, have the proper outlet installed by a qualified
electrician.
3. This product is for use on a nominal 120-volt circuit and has
a grounding plug that looks like the plug in Figure 2. Make
sure that the product is connected to an outlet having the
same configuration as the plug. No adapters should be used
with this product.
4 .If an extension cord is required, use only a three wire
extension cord that has the same configuration as the unit
cord, including the (round) ground terminal. Make sure that
the extension cord is plugged into a properly grounded
receptacle.
5. When using an extension cord, be sure it is in good condition
and heavy enough to meet the specifications in the chart
below. If an extension cord is needed, thef ollowing wire
sizes must be used (See Chart 1).
chart 1 - extension cord Requirements
cord length
gauge
25 foot
10,12, or 14
50 foot
10 or 12
100 foot
10
for information about
this product call
1-800-626-4401
TEST
RESET
Grounding
Pin
figure 2 - grounding plug
