Airless Paint Sprayers
3
Operating Instructions and Assembly Instructions
Safety Guidelines
IMPORTANT SAFETy INSTRUCTIONS
SAvE THESE INSTRUCTIONS
This manual contains information
that is very important to know
and understand. This information
is provided for SAFETY and to
PREVENT EQUIPMENT PROBLEMS.
To help recognize this information,
observe the following symbols.
Danger indicates
an imminently
hazardous situation which, if not
avoided, will result in death or serious
injury.
warning indicates
a potentially
hazardous situation which, if not
avoided, coulD result in death or
serious injury.
caution indicates a
potentially
hazardous situation which, if not
avoided, MAY result in minor or
moderate injury.
Notice indicates
important
information, that if not followed, MAY
cause damage to equipment.
Unpacking
After unpacking the unit, inspect
carefully for any damage that may
have occurred during transit. Make
sure to tighten fittings, bolts, etc.,
before putting unit into service.
Do not operate
unit if damaged
during shipping, handling or use.
Damage may result in bursting and
cause injury or property damage.
General Safety Information
CALIFORNIA PROPOSITION 65
This product or its
power cord may
contain chemicals, including lead,
known to the State of california to
cause cancer and birth defects or other
reproductive harm. wash hands after
handling.
GENERAL SAFETy
1. SAVE THESE
INSTRUCTIONS - To
reduce the risks of fire
or explosion, electrical
shock, and injury to
persons, read and understand
all instructions included in this
manual. Be thoroughly familiar
with the controls and the proper
use of the equipment.
2. Always wear a mask
or respirator and
eye protection when
painting. Be certain
mask or respirator
will provide necessary protection
against inhalation of harmful
vapors.
3. Keep visitors away and NEVER
allow children or pets in the work
area.
4. Do not smoke or eat when spraying
paint, insecticides, or other
flammable substances.
5. Always work in a clean
environment. To avoid injury and
damage to the workpiece, do not
aim the spray gun at any dust or
debris.
6. When spraying and cleaning,
always follow the instructions and
safety precautions provided by the
material manufacturer (Refer to
MSDS).
ELECTRICAL SHOCk HAzARD:
●
Follow all local electrical and safety
codes, as well as the National
Electrical Code (NEC) and in the
United States, the Occupational
Safety and Health Act (OSHA).
●
This product requires a grounded
120V, 15 Amp circuit (See Figure 1).
MANUAL
●
If the power receptacles available
will not fit this equipment’s power
cord, then have an appropriate
power receptacle installed by a
certified electrician.
●
Only qualified electricians or
service personnel should perform
maintenance on the electrical
components of this equipment.
●
Do not modify any of the
electrical components of
this equipment.
●
Do not use a power cord
adapter with this equipment.
●
If using an extension cord, use only
grounded three wire extension
cords that are in good condition.
●
Check with a qualified electrician
or service person if the grounding
instructions are not completely
understood or you are in doubt
as to whether the equipment is
properly grounded.
APPROPRIATE ExTENSION CORD
GAUGE FOR GIvEN LENGTHS
Length of Cord
Gauge
25’
14
25-50’
12
50-100’
10
www.chpower.com
TEST
RESET
Figure 1 - Grounding
Grounding
Pin
