Campbell Hausfeld IronForce IFN328K0, Operating Instructions Manual

ADJUSTING THE FASTENER 
PENETRATION

The tool is equipped with an adjustable 
depth of drive feature. This allows the 
user to determine how deep a fastener 
will be driven into the work surface.

1.   Adjust operating pressure so 

fasteners are driven consistently. Do 
not exceed 100 psi.

2.   To drive the fastener shallower, turn 

the wheel (C) to right to the extent 
desired.

3.   To sink a fastener deeper, turn 

the wheel (C) to left to the extent 
desired.

4.   Make sure trigger and 

work contact element 
(WCE) move freely up 
and down without 
binding or sticking 
after each adjustment.

ADJUSTING THE DIRECTION OF THE 
EXHAUST

The tool is 
equipped with an 
adjustable direction 
exhaust deflector. 
This is intended to 
allow the user to change the direction 
of the exhaust. Simply twist the 
deflector to any direction desired.

6

Operating Instructions

www.chpower.com

OPERATING INSTRUCTIONS 
(Continued) 

CLEARING A JAM FROM THE TOOL

1.   Disconnect the air 

supply from the tool.

2.   Remove all nails from 

the magazine (see 
"Loading/ Unloading 
The Nailer"). Failure 
to do so will cause the 
nails to eject from the front of the 
nailer.

3.   Undo latch by pulling 

out and down. 
The wire latch will 
disengage from the 
hooks on the nose.

4.   The door can now be 

rotated, exposing the 
jammed fastener.

5.   Remove the jammed 

fastener, using pliers 
or a screwdriver if 
required.

6.   Rotate door back into 

the closed position.

7.   Extend the wire latch 

and place over the 
hooks on the nose.

8.   Close the latch by 

pushing the latch up 
and in until the latch 
snaps into place.

9.   Make sure the trigger 

and work contact 
element (WCE) move 
freely up and down 
without sticking or binding.

USER-MAINTENANCE 
INSTRUCTIONS

TECHNICAL SERVICE

Please call our Tool Hotline at 1-800-
543-6400 with any questions regarding 
the operation or repair of this tool or 
for additional copies of this manual.

FASTENER AND REPLACEMENT 
PARTS

Use only genuine 

 Campbell Hausfeld 

18 gauge fasteners (or equivalent - see 
Fastener Interchange Information). 
Tool performance, safety and durability 
could be reduced if improper fasteners 
are used. When ordering replacement 
parts or fasteners, specify by part 
number.

TOOL REPAIR

Only qualified personnel should repair 
the tool and they should use genuine 
Campbell Hausfeld replacement parts 
and accessories, or parts and accessories 
which perform equivalently.

ASSEMBLY PROCEDURE FOR SEALS

When repairing a tool, the internal 
parts must be cleaned and lubricated. 
Parker O-lube or equivalent must be 
used on all o-rings. Each o-ring must be 
coated with O-lube before assembling. 
A small amount of oil must be used on 
all moving surfaces and pivots. After 
reassembling, a few drops of 30W 
non-detergent oil or equivalent, must 
be added through the air line before 
testing.

STORAGE

The stapler should be stored in a cool 
dry place. 

(C)

Movement

Rotate