6
Operating Instructions
www.chpower.com
2. Remove all
nails from
the
magazine
(see Loading/
Unloading).
Failure to do
so will cause
the nails to
eject from
the front of
the tool.
3. Insert a
screw-
driver
into the
nose of
the tool.
Push up
on the driver blade to free the
jammed nail.
4. Grab the
jammed
nail with
pliers
and
remove.
Technical Support
Please call our Nailer Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this nailer or
for additional copies of this manual.
Fastener And Replacement
Parts
Use only
genuine
Campbell Hausfeld fasteners (or
equivalent - see Fastener Interchange
Information). Use only genuine
Campbell Hausfeld replacement parts.
Never substitute parts. Do not use
modified parts or parts which will not
give equivalent performance to the
original equipment. Tool performance,
safety and durability could be reduced.
When ordering replacement parts or
fasteners, specify by part number.
Nailer Repair
Nailer repairs must be performed by
qualified and experienced service
people ONLY.
Assembly Procedure For Seals
When repairing a nailer, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W non-
detergent oil, or equivalent, must be
added through the air line before
testing.
