Campbell Hausfeld SB101000, Operating Instructions Manual

Symptom

Possible Cause(s)

Corrective Action

Air leaking at trigger valve 
area.

O-Rings in trigger valve housing are 
damaged

Replace o-rings 

Air leaking between housing 
and nose.

1. Damaged O-Rings

1. Replace o-rings

2.  Damage to bumper

2.  Replace bumper

 Air leaking between housing 
and cap.

1.  Loose screws

1.  Tighten screws

2. Damaged gasket

2. Replace gasket

Tool skips driving fastener

1.  Worn bumper

1.  Replace bumper

2.  Dirt in nose piece

2.  Clean drive channel

3.  Dirt or damage prevent fasteners or 

pusher from moving freely in magazine

3. Clean magazine

4.  Damaged pusher spring

4.  Replace spring

5.  Inadequate air flow to tool

5.  Check fitting, hose, or compressor

6.  Worn O-Ring on piston or lack of 

lubrication

6.  Replace and lubricate o-rings

7.  Damaged O-Ring on trigger valve

7.  Replace o-rings

8.  Air leaks

8.  Tighten screws and fittings

Tool runs slow or has loss of 
power

 1.  Tool not lubricated sufficiently

1.   Lubricate tool

2.  Broken spring in cylinder cap

2.  Replace spring

3.  Exhaust port in cap is blocked

3.  Replace damaged internal parts

Fasteners are jammed in tool

1.  Guide on driver is worn

1.  Replace guide

2.  Fasteners are not correct size

2.  Use only recommended fasteners

3.  Fasteners are bent

3.  Replace with undamaged fasteners

4.  Magazine or nose screws are loose

4.  Tighten screws

5.  Driver is damaged

5.  Replace driver

6.  Fasteners loaded incorrectly

6.  Review Loading / Unloading section of this 

manual

Troubleshooting Chart

Stop using tool immediately if any of the following problems occur. Serious personal injury could occur.  

  Any repairs or replacements must be done by a Qualifi ed Service Person or Authorized Service Center.

6

Operating Instructions

www.chpower.com