GETTING TO KNOW YOUR UNIT
SET UP INSTRUCTIONS
* Items shown in Set Up Instructions are not included with this tool.
BEST PRACTICES
u
The air compressor used with your air hammer must be able to maintain a
minimum of 90 PSI when the tool is being used. An inadequate air supply can
cause a loss of power and inconsistent tool output/performance.
u
A pressure regulator—used at the tool—is helpful to control the operating
pressure of the tool and maintain 90 PSI.
u
Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or “gum up” internal parts of the tool.
u
To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
u
Make sure that the chisels used with your pneumatic air hammer are heat-treated
steel for increased durability and longer life.
3
Trigger
Spring Retainer
Air Inlet
Exhaust Port
Threaded Barrel
Plug
Quick
Coupler
Air Hose
Spring Retainer
Chisel
Whip Hose
