Automatic Weather Station with UT20/UT30 Tower
S-2
S.3 Before Assembly
Before assembling the tower ensure that all parts of the tower, appropriate sensors,
tools and safety equipment are readily available. A full equipment list is given in
the Introduction Section of this manual.
Never use damaged or incorrect components. If in doubt
about the suitability of any component or equipment
please seek expert advice.
S.4 Do Not Climb The Tower
Although the design of the tower produces a well made and strong structure,
do
not attempt
to climb the tower for any purpose.
It is possible to install and service the sensors and raise and lower the tower using
the base assembly as a hinge. A detailed explanation of how to fit the sensors and
other components while the tower is on the ground is given in Section 2 of this
manual.
DO NOT CLIMB the tower, whether guyed or unguyed, for
any reason. Carry out the fitting and maintenance of all
high-level sensors with the tower on the ground as
detailed later in this manual.
S.5 Maintenance
S.5.1 Structure
It is important to carry out maintenance at regular intervals as detailed in Section 2
of this manual in order to preserve the overall integrity of the structure. Take special
care to inspect for any rust or corrosion on the bolts, guy wires (where fitted), clips
and ground anchors, especially at ground level, where pockets of moisture may exist.
S.5.2 Electrical
Check all wiring and electrical connections regularly for signs of wear or damage,
including all earth connections.
Where mains power is involved it is essential that you
check for effective earthing of components before any
maintenance work or testing is carried out.
WARNING
WARNING
WARNING
