Section 2. Assembly of Components and Erection of Tower
2-11
With the tower erected and levelled, mount the enclosure as follows:
1. Mount one bracket on the top two holes of the enclosure and the other on the
two bottom holes. The 8 mm bolts supplied are used to attach the brackets. Fit
the brackets with the ‘V’ cut-outs pointing away from the back of the
enclosure. See Figure 2-10, below.
Figure 2-10 Fitting the Enclosure
2. Offer up the enclosure to the tower uprights and present the ‘V’ bolts from the
other side of the tubing to fit into the two matching central holes of the
bracket.
3. Tighten the ‘V’ bolts up against the tower and brackets using the 6 mm nuts.
2.7.4 Mounting a Solar Panel
If you are using a solar panel with your weather station, you will need to consider
the most suitable position with regards to both operational and anti-vandalism
requirements.
Figure 2-11 Fitting the Solar Panel
Mounting Brackets
‘V’ cutout in bracket